Forum > GPU crunching
V10/11 of modified SETI MB CUDA + opt AP package for full multi-GPU+CPU use
Jason G:
--- Quote from: elec999 on 28 Feb 2009, 11:28:08 pm ---My Boinc keeps on getting stuck on communicating with client.
Thank you
--- End quote ---
Hmm, not sure what would cause that. That might be a better question for on NumberCrunching forum. (Unless anyone else around here has some better ideas? )
Raistmer:
About all work get problems.
It's BOINC issues. Science apps don't request work at all, they just process tasks BOINC give to them.
So these problems are not the topic of this thread. Much better to report them on BOINC own forum.
But doing this don't forget that if there is no work for particular app (AP or MB) at this moment then no BOINC version could get work in that case.
Raistmer:
Version of CUDA MB w/o affinity lock mod attached here.
[attachment deleted by admin]
Jason00:
--- Quote from: Raistmer on 01 Mar 2009, 10:37:21 am ---Version of CUDA MB w/o affinity lock mod attached here.
--- End quote ---
Call me dumb but what does this do?
Raistmer:
--- Quote from: Jason00 on 01 Mar 2009, 11:07:47 am ---
--- Quote from: Raistmer on 01 Mar 2009, 10:37:21 am ---Version of CUDA MB w/o affinity lock mod attached here.
--- End quote ---
Call me dumb but what does this do?
--- End quote ---
It's replacement for CUDA MB part of V10a packs. Intended to improve performance on multy-GPU hosts. As was shown on main site current builds stops (all) when one of CUDA apps loads its new task. If you have only single GPU board you don't need this upgrade at all.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version