Forum > GPU crunching

AK V8 + CUDA MB team work mod

<< < (36/51) > >>

Archangel999:
will test this night
Thanks

Best Regards
D.Draganov

ofp1:
Hi,
I am using Raistmer's V8a SSSE3 on a Quadcore 9550 and a GTX260  with cc_config.xml <ncpus>5</ncpus> option  and setiathome 6.4.5 on vista ultimate 32 bits, it was running ok  5 workunits at a time and the computer RAC climbed from 4600 to 7400 and still up but now I noticed that still are procesing 5 WU at a time but the CUDA seems to be not working  the GPU temperature is down (when it was crunching was about 74 and now is 50) and the procesing time is the same in all 5 WU, also in the BOINC messages  says NO CUDA device detected and it was detected before, and I am running out of WU's because it says "Project has no jobs available". What can I do? how do  I know if the GPU is working?
Thanks

Raistmer:
1) How you could know GPU is working - you already used right method - looked at GPU temp.
If temp = idle temp - GPU idle, if temp increased - GPU working hard.

2) If you have no work from SETI then you probably doing another non-CUDA enabled projects. So your CPU will do 5 CPU tasks and no CUDA ones.
Try to get new tasks for SETI MultiBeam.

ofp1:

--- Quote from: Raistmer on 11 Feb 2009, 03:17:38 pm ---1) How you could know GPU is working - you already used right method - looked at GPU temp.
If temp = idle temp - GPU idle, if temp increased - GPU working hard.

2) If you have no work from SETI then you probably doing another non-CUDA enabled projects. So your CPU will do 5 CPU tasks and no CUDA ones.
Try to get new tasks for SETI MultiBeam.

--- End quote ---
Hi,
I am only running SETI, I still have some WU's but no one have been crunched by the GPU since yesterday and BOINC is not recognising my CUDA device.
How do I get new tasks from SETI MultiBeam?

Raistmer:
Link on your host, please ?

Navigation

[0] Message Index

[#] Next page

[*] Previous page