Forum > Linux
SETI MB CUDA for Linux
sunu:
Well, just play with that AR value to keep both CPU and GPU busy till new WUs come out to refill your cache.
riofl:
hmmm don't remember if i asked this before, but is this -9 result overflow message anything to worry about. i have seen it a few times. the wu was validated and credit given though.
Work Unit Info:
...............
WU true angle range is : 0.508292
SETI@Home Informational message -9 result_overflow
NOTE: The number of results detected exceeds the storage space allocated.
Flopcounter: 27434172839395.402344
Spike count: 28
Pulse count: 2
Triplet count: 0
Gaussian count: 0
called boinc_finish
</stderr_txt>
]]>
sunu:
These result overflows are common. You should pay attention though if you generate a lot of these while your wingmen return "good" results. In this case it could be a hardware problem in your part and these results will be invalid.
riofl:
--- Quote from: sunu on 02 Sep 2009, 07:29:37 pm ---These result overflows are common. You should pay attention though if you generate a lot of these while your wingmen return "good" results. In this case it could be a hardware problem in your part and these results will be invalid.
--- End quote ---
hmm. i got two of these from the 285 since i started cuda back up with the vhar units. i ran a memory tester i got off the net which showed good on all available memory.. and i am not geting any strange things happening to the machine or the desktop or movies when i push the gtx a little bit. might have been luck-o-the-draw. ill just have to keep an eye on this.
riofl:
ok my mistake. those were from yesterday when i ran out of units... no way to sort by date i assumed newest were first then i actually read the date :P all of the 2 sept ones were fine.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version